When you're choosing the best Wayne sump pump for your basement, you'll want to compare the discharge rate, materials, float switch, horsepower, etc: I highly recommend the Wayne CDU800 sump pump because it can move up to 4,200 gallons of water, per hour, out of your basement, it has a cast iron base, and it has a reliable vertical float switch.
Cast iron can rust, so the Wayne sump pump CDU800 is coated with a durable epoxy to help guarantee decades of reliability. Additionally, this Wayne sump pump features a sealed bearing case to reduce the amount of maintenance that you have to perform.
Each will automatically shut off the pump; however, vertical floats are easier to maintain and far more reliable than the other two types. Horsepower: as we talked about the Wayne sump pump CDU800 is powered by a ½ hp hermetically sealed motor.
A ½ hp motor will allow the sump pump to push discharged water over greater distances. This helps to ensure that discharged water does not drain back into your basement or crawlspace.
Additional features: the features we talked about, above, should be your primary focus when you’re comparing sump pumps, but you may want to consider these aspects of the Wayne sump pump as well: as you shop, keep in mind that this Wayne ½ hp sump pump offers lightning protection, has a two-pole switch and is extremely quiet due to the watertight seals. Cast iron lasts longer than plastic which saves you money over the long run.
Third, unlike some other sump pump manufacturers, Wayne offers a three-year limited warranty, for your peace of mind, on the CDU800. The second is that a cast iron base on Waynesumppumps will dissipate the heat from the motor into the water in the sump pit.
Heat dissipation is key to a submersible sump pump lasting for years. For both the Waynesumppumps reviewed on this page, Wayne offers a 3-year Limited Warranty.
And of course, all Waynesumppumps are not covered under warranty if they fail because of abuse, misuse, improper maintenance or installation. The Wayne ½ HP sump pump can tackle greater vertical distances.
Quality: each pump is made of durable cast iron with stainless steel fasteners, so construction of each is top-notch. Where the two diverge is in the number of gallons discharged and the vertical distance the effluent can be pumped.
400 gallons per hour can be the difference between a dry space and a huge repair bill. It also means that the CDU800 pump will run for shorter periods of time, reducing the chance it will overheat and fail.
I thought you might like to see this short video, from the Waynesumppumps company, that highlights some features of the Wayne CDU790. Contractors don’t like to be called back to fix their plumbing work from a previous job.
They don’t want to go back to an old job and face an angry homeowner or wet basement. You can find them online at any equipment retailer, or you can order them from any Wayne sump pump dealer.
If you’re not sure if you have a local Wayne dealer, you can visit the website to find where to buy parts. I hope you got a few good tips about sump pump float switch replacement from this video.
It’s easy too just to give my opinion that the Wayne sump pump CDU800 is one of the best sump pumps on the market, but that would leave you with a sense that you do not fully understand why. They are generally made of cheap plastic parts and do not last as long as a cast iron submersible sump pump.
Submersible sump pumps like the Waynesumppumps only require a flat surface to sit upon within the sump pit. That means you do not need added bracing, and you can cover the sump pit to reduce the noise coming from the pump itself.
Cast iron submersible sump pumps last longer than plastic pumps because they are coated to prevent corrosion. Perhaps the greatest advantage that a submersible sump offers is that the motor is hermetically sealed against water.
That means that the pump will continue to work so long as it has a power source, better protecting your home against flooding. Choosing the best sump pump for your basement can be hard, two of the most popular brands are Roller and Wayne.
Wayne and Roller make a number of sump pumps with different powered motors ranging in price from about $100 to over $250. They are popular with homeowners across the Midwest and North East to protect their basement thanks to the dependable pump and reliable vertical float switch.
While the pumps may not have much motor protection or advanced features of Roller models they are still a good choice for their cost. One of Wayne’s most popular pumps is the Water bug which costs less than $100 and is a good option for homeowners on a budget.
Wayne WSS30VN Battery backup works when the power dies Great flow, even from the backup Quiet operation CHECK PRICE Liberty Pumps 257 One-piece cast iron housing Handles solids up to 1/2” CHECK PRICE Watergate WA50CPED 5,000 MPH flow rate Quiet operation Accessible motor CHECK PRICE No matter how much water you need to remove, this pump can handle it and keep your home dry, with a flow rate of 4,600 gallons per hour (MPH).
This robust pump is tested to one million cycles, ensuring a long life expectancy. To help you sleep better at night knowing your pump won’t fail, a five-year warranty is included.
Most homeowners can save money by completing the installation on their own without the need for a professional. When pumping water 10 feet vertically, it is still capable of moving 1,200 gallons per hour.
While this is great flow for the price, it’s only about one-third of the amount of water that the sump pump in our top spot can move. Double O-ring seals and heavy-duty construction provide peace of mind, and the screen filters out large debris.
The pump itself can handle up to 1/8” solids with ease, so you don’t have to worry about little pebbles and leaves ruining your system. It also features multiple discharge and hookup options to make it simple to set up for any homeowner.
Low price Multiple hookup options Filters debris and can handle solids up to 1/8” No matter how much rain is pouring down outside, this pump will keep your home dry, even with no electricity.
While this pump provides incredible peace of mind with its battery-powered backup, it does come at a high price. This keeps the motor safe from any sort of exterior damage, helping improve its life expectancy.
While this is a decent flow for a sump pump, it can’t quite compete with our top contenders. If you find the need to constantly clear your pump of debris to be annoying, then this feature may be an important factor in your decision.
Other pumps at the same price point offer higher flow rates and better warranties. This means you won’t have to spend time cleaning and unclogging your pump.
Despite the high water flow and easy accessibility of the motor, this pump is very quiet. If your current pedestal pump sounds like a jet engine, this unit is a great choice for an upgrade.
Because it can remove water down to 1/16”, this pump is a great choice for smaller sump pits that only fill up on occasion. For this reason, this pump is not a great choice for full-size sump pits or anywhere where maximum water flow is a necessity.
All plastic housing and components don’t inspire confidence in this pump’s longevity, nor does the lack of any available warranty information. This unit is also known to occasionally deliver an electrical shock when trying to adjust the cutoff switch.
This submersible sump pump from Watergate is priced near our highest rated sump pumps on this list, but it lacks the same features and longevity. The impeller is made of plastic, though, which doesn’t inspire confidence when it comes to passing small stones, sticks, and other debris.
No warranty information High price for the features Aluminum construction instead of cast iron With 4,400 MPH flow, this pump won’t match its top competitors, but it’s not terrible by any means.
Over-priced for its longevity Likely to die in the first two years Easily blocked by debris Loud compared to competitors After reading our reviews of the best sump pumps currently available, you know which pumps we recommend.
Although they both provide the same results (a nice dry basement), they have very different features, pros, and cons. This pump sits above your basin or underground area where the water accumulates.
In this case, the motor is housed in the above ground part while a pipe and propeller are installed into the basin to move water up and away from your basement. One great feature of this type of sump pump is it’s easy to install and repair when needed.
Just like any machine, it will eventually need maintenance and having it within reach makes life easier. In this case, the entire machine is instilled inside your basin and below the waterline.
As you can imagine, this type of pump is not easy to fix when it needs repair or maintenance. While a pedestal sump pump can last upwards of 25-years, a submersible option will likely need to be replaced after 10 to 15-years.
It runs off your main electric line, therefore, any potential power outages will render your pump useless. This option gives you the power of electric sump with the emergency back up of a battery-operated unit.
A sensor in the machine alerts it to a power failure, and it will automatically switch to the battery. The only thing you have to remember is to make sure the battery is charged and ready to go when the weather is bad.
The main difference is it can pass debris up to 2 inches, and it is used when wastewater collects at a lower point than the septic line. Some models can also turn waste into a slurry to move it more efficiently through the piping system.
That being said, if you have a higher amount of debris where the water accumulates in your home, this type of system can be useful. This is a newer type of system that uses the natural flow of water to power the unit.
Keep in mind, you need to have town or city municipal water for this pump to work. Credit: State, Shutterstock Now that you know the different options you have for a sump pump, there are still a few more details to keep in mind.
That being said, the sump pump is used to propel water from the lowest accumulation point. For it to be effective, it needs to be powerful enough to move water vertically and horizontally.
In fact, a pump with too much power can cause your motor to burn out quickly. The flow rate measures how much time it takes for your sump to pump the water out.
For example, if you live in an area where you have torrential downpours regularly, you will likely need a higher flow rate. Although we have already covered the most important aspects of a sump pump, there are a few other features you should be aware of before making a final decision.
Newer models have wide flow options or wave-making capabilities that will save on your energy costs, plus it will extend the life of your pump motor. It also helps to lower the water temperature which will also extend the life of your motor.
Pressure activated can fail to turn off when the storm has passed allowing your motor to burn out. Now you have the information to make a sound decision when purchasing your new sump pump.
The high flow rate, five-year warranty, and long life expectancy all add up to the best feature set and quality available. With a 1,800 MPH flow and ability to handle solids up to 1/8”, this pump may not have the strongest feature set on this list, but the low price point and high reliability make this pump the best choice for the money.